![]() Working this way and bypassing the dedicated ASIO drivers provided by your interface manufacturer is very likely to result in reduced stability and increased latency performance of your ASIO interface. People have had trouble with ASIO4ALL to aggregate their multiple interfaces due to the nature of ASIO4ALL.ĪSIO4ALL, as far as I know, wraps the WDM driver and presents that as ASIO to the OS. So it should be relatively simple for him to just try it out. I don't have different interfaces to try this, but I presume the OP has. The first hurdle is to see whether two instances of Reaper (which is quite do-able)can have different interfaces. So the idea is to load up two instances of Reaper, set one instance to look at the Behringer and its input channels, the other to look at the Tascam and its input channels to increase the total number of channels that can be recorded simultaneously. I think it's input channels the OP is interested in, not output channels. What do you plan to record into / onto / to? That gives you 24 stereo outputs in total, or 48 mono outputs.įrom what ppl have told me about my own planned setup, mono channels are OK as long as l don't have FX on the channel too. explain your setup in complete detail, because there are many possible answers and each one is complex. The next thing you must do is state how you want to record 2 instances of Reaper simultaneously, i.e. The stuff about ASIO routing was just to trace out possible solutions and l cannot flesh these ideas out without you explaining your actual setup, because each ASIO solution in my opinion is exceedingly complex and l will only be able to be specific if you can be specific, and even then it's probably better to ask an expert Please take with a pinch of salt all of what l have said except how to open multiple Reaper instances. There is also Voicemeeter and O Deus ASIO Link. BUT: Nope, 2 DAWs cannot use the same soundcard. I would have thought that you could also use another ASIO driver (ReaRoute is an ASIO driver but there are others too) with a soundcard, and channel Reaper instance #2 to record into Reaper instance #1? Make sure both Reaper instances use the same ASIO driver, and then open a track in Reaper instance #1, and make sure it takes the correct inputs to correspond with Reaper #2's soundcard outputs for a given track. you guessed it, ReaRoute, but l haven't a clue how it works, ask the experts. To record both Reaper instances, you could use. Target DAW = "ReWire Master / Host", first instance of Reaper = "ReWire Slave". You can only use ReWire with the first instance of Reaper, and you'll have to open the target DAW first, before you open your first instance of Reaper. Let's say you wanted to record to another DAW. But you might be able to do it via ReaRoute ASIO but l have no clue about ReaRoute ASIO, you'll have to pitch that to the experts. Let's say you wanted to record to a 3rd instance of Reaper. a 3rd instance of Reaper, another DAW (64-bit), another DAW (32-bit), a hard disk multitrack recorder, or the traditional burn directly to pizza. "check for multiple instances when launching"Īnd yes, you can record both simultaneously but it really depends on what you wish to record to, e.g. You can however use two instances of REAPER. Quote: "Tabs are a good way to go for most tasks. You can open multiple instances of Reaper like so:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |